STYLUS ILLUMINATOR (Detachable Mini Light)
The small light for the stylus illumination is
available as an optional extra.
REMOTE CONTROL
In cage you wieh to control the START/STOP with
using external equipment like a foo~switch etc., input
jack is provided at the left side of rear panel.
QUARTZ LOCKED CONTROL AND PITCH ADJUSTMENT
1. Whan the indicator lamp is lit ehowing
the
uporating condition tar the pi-e-determined spec.d
(33-H Or 45 rpm).
Z.During the operation of m-e-determined speed, pitch
control fader can not be functioned. And once press
the quarts control button, the indicator lamp is put
out, the speed can be adjusted by pitch control
fader.
3. During the operation of above 2., if you want to
change the speed to the pre-determined one, press
the quartz butlon. The indicator lamp lights and
speed will become pre-dotermined one even when
the pitch control fader not in the center.
4.Pitch control is poseiblo up to a maximum of
approximately rtlO%. Adjust the Pitch by sliding
the Pitch Control Fader.
ACOUSTtC FEEOEACK AND HUM
Acoustic Feedback is uaally caused by vibration of
speakers, which affects the ecnsitive cartridge. If such
a phenomenon occurs,
relocate the turntable or
speakers as far apart from each other as possible.
Hum ie usually caused by nearby appliances that use
transformar or thermostat. Relocating the unit
further away from the noise sources will readily
solve the problem. Hum may also be produced if the
unit is not properly grounded.
Make sure the
grounding wire extending from the unit is securely
connected to the GND terminal on the amplifier or
mixer.
INSTALLATION
Do not place the unit where it is exposed to direct sun
/jointfilesconvert/557644/bght, high temperature or humidity to prevent
pesslble troubles.
Place the unit in a stable and holizontal position,
where there is little or no vibration.
Locate the unit as far away from the speakers as
possible and isolate the unit’ from sound radiation
from them.
rf the unit is placed too close to the radio,
xnterference to AM/FM reception may result.
CONNECTION
COIU
lect the output to inputs of amplifier or mixer.
WHITE(t)
. . . . . ..I . . . . . m.L
RED(R)
ChmnDl
..v . . . . . . . . I, . . . . . R
GND
Chansl
..*... . . . . . . . . ..I. . . . . . . GNl-j
Note
Be sure to connect firmly-the GND terminal t,o
the amplifier or mixer, or a power source
HUM will result..
Relationship between Pitch and Fader Position
PITCH WY.-
-Ii-
(14 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals