ASSEMBLY AND SET-UP
Installation of Turntable Flatter
1. By placing the turntable platter on the center
spxndle, the platter adjusts to match the spindle by
itself
2. Place the slip mat on the platter.
3. Extra care should be taken to avoid damaging
magnet by dropping it.
Installation of Balance Weght
Place tlrw bdww
weight on the rear shaft of the
tonearm (see fig. 1)
winding the balance weight clockwise.
Installation of Cartridge
In accordance with the instructions of the cartridge,
m&all a cartridge properly.
In caee the cartridge weight is less than 8g, it is
necessary to fix the attached shell weight on the
cartridge.
Connect the lead wires to the cartridge terminals
The terminals of rnoet cartridges are color corded’
Connect each lead wire to the terminal of the same
color.
Red
(R+)
Green CR-)
.*...*e*** *-Right Channel t
***m.*-*-sowRight Channel -
m,.*.*m*.*e*Left Channel +
be..*..***a*Left Channel -
LEAD wmd
NUT,
Adjustment of Overhang
Use a rule, etc. to carry out correct adjustment,
As shown in the illustration, overhang indicates the
distance from the stylue tip to the center of the
turntable spindle when the stylus tip falls on the
extension of e straight line from the pivot of the
tonearm to the center of the spindle. If the overhang
adjustment ls not properly made, the stylus
be able to trace the record grooves correctly.
will not
1. Loosen the two cartridge mounting screws.
2. Position the tonearm over the spindle.
3. Slide, the cartridge forward or backward until the
position of the stylus tip corresponds to the
specified distance from the center of spindle (see
illustration).
4. After, obtaining correct overhang,
cartrIdge mounting 8~2-9~~ firmly.
tighten
the two
Note : Be shure not to touch stylus during adjustment
with finger.
Adjustment of Horizontal Zero Balance
1. Release the tonearm from the armrest to free.
Note 1 Be careful not to touch your hger to the
stylus tip.
2. Turn the balance weight clockwise or counter
clockwise until the tone arm is balanced
horizontally.
3. (see fig. 4)
aExcessive backward retreatment of the
balance weight causes the cartridge side
to be r&d
b-The balance weight and cartridge are
balanced, the tonearm is held horizontal.
c.Excessive forward advancement of the
a
balance weight causes the cartridge side
to be lowered.
4. Return the tonearm to the armrest.
4)
-3-
(14 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals