Vestax PMC-25 User Manual

Professional Mixing ControllerVESTAX CORPORATIONVESTAX AmericaVESTAX(Europe)Ltd.OWNER'S MANUAL

9HOW TO CHANGE THE JACK PANEL POSITIONThe I/O jack panel of the PMC-25 can be placed either on the top or back side of the unit. Please refer tofollo

10BLOCK DIAGRAM

Vestax CorporationSPECIFICATIONINPUTSECTION MIC（1/4 INCH PHONE JACK） -50dBv -20dBv 3.3kΩ PHONO 1∼3L/R （RCA PIN JACK） -42dBv -22dB v 56k

1CONGRATULATIONS！The lightning flash with arrowhead symbol，within an equilateral triangle，is intended toalert the user to the presence of uninsulated“

21. Read instructions-All the safety and operatinginstructions should be read before the applianceis operated.2. Retain instructions-The safety and op

315. Damage Requiring Service-Unplug this productfrom the wall outlet and refer servicing toqualified service personnel under the followingconditions:

4FUNCTIONSPROGRAM SECTIONMONITOR SECTIONMIC SECTIONPROGRAM SECTION MASTER SECTION○1INPUT SELECT (Input Select Switch)Used to select input to be sent t

○7HI CUT (Fader type cut switch HI)When this volume is set to bottom position, highfrequency range is cut of completely regardless ofthe position of t

6HOW TO REPLACE THE CROSS FADER●Remove four screws, which hold the fader unit panel.●Remove the cross fader unit, CF-R.●Carefully remove the multi-cab

7REAR PANEL SECTION252824 27 32 33 31 30 29 26 25 24 27○24PHONO 1,2 [RCA PIN JACK]Connect turntables equipped with MM (MovingMagnet type) cartridge. T

8CONNECTION EXAMPLEPLAY/PAUSECUEPLAY/PAUSECUEKEYPITCHREVERSEOPEN/CLOSESTOPDISPLAYREPEATABSEARCHTRACKMIN SEC FRM ENTER 123LOOPSTARTENDRELOOP/EXITPOINT