Vestax PDX-2300MK2 Owner's Manual download pdf (Page 10)

A Tone arm height adjustment may be necessary for some

cartridge types. The height can be adjusted up to 9mm by rotating

the arm height adjustment screw.

Cartridge height 16mm

Cartridge height 25mm

Rotate

this part

Balance Weight

Counter Ring

Rotate

this part

Balance Weight

Counter Ring

Arm Height Adjustment Screw

If the balance weight is moved, readjust the horizontal

balance again.

If you put too much pressure on the stylus, it can

cause the stylus to jump during scratch play and will

shorten the stylus's life.

Be sure to tighten the arm height adjustment screw

well. The stylus may jump/skip if the height setting is not

secured.

q Hold the balance weight with one hand as shown in the

drawing, and rotate only counter ring to bring the numeral "0"

of the ring into alignment with the center line on the tone-arm

rear shaft.

w Turn the balance weight to present the reading on the gauge to

the designed stylus force of your cartridge.

As counter ring moves in step with the balance weight, proper

stylus pressure can selected by reading the graduated ring

directly.

Tone arm height adjustment

Dynamic Needle Pressure

Adjustment Knob

Loose Close

Dynamic Needle

Pressure

Adjustment Knob

q Loosen the dynamic needle pressure adjustment knob and pull

it to the position with appropriate needle pressure, the tighten

the knob.

Adjustment of Stylus Puressure

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Vestax PDX-2300MK2 Owner's Manual Page 10